To use WPS to set up your extender, follow these steps: 1. Set the Access Point/Extender switch on your extender to Extender. 2. Connect your extender to your router in the same room. 3. The LED lights with the most power. 4. Press the Power or On/Off button if the Power LED does not light up. 5. Wait for your extender's LEDs to stabilise. 6. It may take a few minutes to complete this task. 7. WPS (Wi-Fi Protected Setup): Press the WPS button on your router. 8. The WPS LED extender turns on and stays on. 9. Unplug the extender and relocate it to a new location halfway between your router and the area with a weak WiFi signal. 10. Wait for the Power LED to light up after plugging in your extender. 11. Use the Router Link LED to help you find the best location for the extender-to-router connection. 11. Join the extended network with your WiFi-enabled computer or mobile device. 12. The extended network name is one of the following, depending on your extender: 13. It's the same as your old network: MyWiFiExample 14. The same as your original network, but with the addition of _EXT: MyWiFiExample EXT 15. The same as your original network, but with the addition of _2GEXT or _5GEXT: MyWiFiExample 2GEXT and MyWiFiExample 5GEXT are two examples of WiFi networks. 16. The same as your original network, but with the addition of _2G or _5G: MyWiFiExample 2G and MyWiFiExample 5G are two examples of WiFi networks. 17. The password for the extender network is the same as your original network's password.