https://www.cmetechnology.com/other-standard-for-testing-equipment/
Other Shock Testing Standards
Motion Simulation Testing Standards
Other Standards Different Testing Equipment Should Meet
Other Shock Testing Standards
EN 61373 Shock Testing Standa...
Oops! This image does not follow our content guidelines. To continue publishing, please remove it or upload a different image.
Other Shock Testing Standards
Motion Simulation Testing Standards
Other Standards Different Testing Equipment Should Meet
Other Shock Testing Standards
EN 61373 Shock Testing Standards
EN 61373 / IEC 61373 standard specifies the requirements for testing items of equipment intended for use on railway vehicles which are subsequently subjected to vibrations and shock owing to the nature of the railway operational environment. To gain assurance that the quality of the equipment is acceptable, it has to withstand tests of reasonable duration that simulate the service conditions seen throughout its expected life.
RTCA/DO160G Shock Testing Standards
Section 7 Operational Shocks and Crash Safety The operational shock test verifies that the equipment will continue to function within performance standards after exposure to shocks experienced during normal aircraft operations. These shocks may occur during taxiing, landing, or when the aircraft encounters sudden gusts in flight. This test applies to all equipment installed on fixed-wing aircraft and helicopters. Two operational shock test curves are provided; a standard 11 ms pulse and a low frequency 20ms pulse. The 20 ms pulse may not be adequate to test against the effect of longer duration shocks on equipment that have its lowest resonance frequency (as per section 8) below 100Hz. For such equipment, a pulse of 100 ms duration should be considered.
The crash safety test verifies that certain equipment will not detach from its mountings or separate in a manner that presents a hazard during an emergency landing. It applies to equipment installed in compartments and other areas of the aircraft where equipment detached during an emergency landing could present a hazard to occupants, fuel systems, or emergency evacuation equipment. These tests do not satisfy FAR requirements for all equipment, e.g. seats and seat restraints.
KRD10 Hydraulic Vertical Shock Tester
KRD11 Pneumatic Vertical Shock Test Machine
KRD12 Pneumatic Horizontal Shock Test Machine
KRD13 High Energy Shock Test System
KRD17 Bidirectional Vertical Shock Test System
Other Vibration Reliability Test Standards
EN / IEC 61373 Vibration Testing Standards
EN 61373 specifies the requirements for testing items of equipment intended for use on railway vehicles which are subsequently subjected to vibrations and shock owing to the nature of the railway operational environment. To gain assurance that the quality of the equipment is acceptable, it has to withstand tests of reasonable duration that simulate the service conditions seen throughout its expected life.
RTCA DO 160 G Vibration Testing Standards
These tests demonstrate that the equipment complies with the applicable equipment performance standards (including durability requirements) when subjected to vibration levels specified for the appropriate installation. The vibration tests described below apply to equipment installed on the fixed-wing propeller, aircraft, fixed-wing turbojet, turbofan, and propfan aircraft and helicopters.
The specific vibration tests to be performed to show compliance with the performance standards are defined in this paragraph and are dependent upon three identifiers: (1) aircraft type, (2) test category, and (3) aircraft zone location. The requirements and procedures to accomplish these tests are specified in subsequent paragraphs herein.
Other Vibration Testing Standards
KRD70 Hydraulic Vibration Shaker
Motion Simulation Testing Standards
AC156 Motion Simulation Testing Standards
Triaxial Test: A dynamic test in which the test specimen is subjected to acceleration in two principal horizontal axes and the vertical axis simultaneously. The two horizontal and the vertical acceleration components are derived from three different input signals that are phase-incoherent.